Skip to main content
Help
Editing Step 6 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Place the new speakers into the circular mold that held the old speakers, making sure to align the notch inside the molds with the indents on the outer rim of the speakers.

Replace the two metal brackets and all four screws—one bracket and two screws for each speaker—to keep the speakers in place.

Holding them such that the visible metal contacts are facing up, insert the white plastic end of each speaker wire into their respective connection ports on the circuit board.

Replace the tape securing the wires to the panel.

NOTE: If you are not replacing the keyboard, proceed to "Step 8".

Your contributions are licensed under the open source Creative Commons license.