Skip to main content
Editing Step 14 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 8 guides that include this step.

Step Type:

Drag to rearrange

The microphone hole is the center hole flanked by two larger holes.

Align the adhesive strip to the bottom edge by positioning the microphone notch over the microphone hole.

If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend sits next to the right vertical adhesive. The L-bend should not overlap the right vertical adhesive.

The adhesive tears easily. Be careful not to pull on the strip with too much force.

Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment.

Your contributions are licensed under the open source Creative Commons license.