Skip to main content
Help
Editing Step 6 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Use a spudger to pry the hard drive away from the interface board. Wedge the flat end of the spudger between the interface board and the far right side of hard drive and wiggle back and forth until the hard drive slides out about a sixteenth of an inch. Then move to the other side and repeat the procedure. Go back and forth until the hard drive slides free.

When reinstalling the hard drive, make sure that you don't slide the top pins into the lower row of holes.

Your contributions are licensed under the open source Creative Commons license.