Skip to main content
Editing Step 5 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 5 guides that include this step.

Step Type:

Drag to rearrange

Insert a spudger just to the left of the hinge opening on the top edge of the display between the front display bezel and the plastic strip attached to the rear bezel.

Pry the rear bezel away from the front bezel along the top left half of the display.

If the flat end of your spudger is flexing too much, trim about .125" of the end to increase its stiffness.

Your contributions are licensed under the open source Creative Commons license.