Skip to main content
Help
Editing Step 4 —

Step Type:

Drag to rearrange

Now, lift from the right side the board, and be careful, below is the LCD connector.

It´s turn to the HOT STATION. If you don´t have one of this, you can do it with a Hairdryer or a Heat gun

I don´t have any photo of the proccess, so I´m sorry for that. You must heat all the LCD area, and with special attention on the top and bottom areas.

Please be careful with the 2 lower buttons, they have this orange flat cable!!

As you can see, the LCD is totally destroyed, but it was broken before, so...

Your contributions are licensed under the open source Creative Commons license.