Skip to main content
Help
Editing Step 8 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Remove the following screws securing the logic board to the rear case:

Two 2.3 mm Phillips screws

Three 2.7 mm standoff screws

Standoff screws are best removed with a standoff screwdriver or standoff driver bit. A small flathead screwdriver can also do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

Your contributions are licensed under the open source Creative Commons license.