Editing Step 4 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Join the lead leaving the resistor to the stripped end of the wire by twisting the two together.

The wire we are using is quite thick, so we inserted the resistor lead down the center of the conductor portion of the wire and twisted the wire against it as tightly as possible.

Solder the wire to the resistor.

It is essential that enough solder flows through the wire to create a permanent bond between the two pieces.

Your contributions are licensed under the open source Creative Commons license.