Skip to main content
Help
Editing Step 5 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 5 guides that include this step.

Step Type:

Drag to rearrange

From each complete hinge assembly, remove two Torx T6 screws from the outside of each set, leaving two remaining in the middle of each hinge. On each side, the two screws closer to the edge of the computer are shorter than the two screws closer to the center of the computer. Then remove the two inner screws from each hinge assembly. There are 8 screws total.

Your contributions are licensed under the open source Creative Commons license.