Skip to main content
Help
Editing Step 2 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 10 guides that include this step.

Step Type:

Drag to rearrange

The picture at left (rear panel already removed) shows the locations of the metal clips (shown in red) that snap on to the front display bezel. In the next few steps, you will use a small flathead screwdriver to release these clips from a ridge around the perimeter of the front display bezel.

When prying in the following steps, be sure not to damage the antenna cables that run around the perimeter of the front display bezel.

Your contributions are licensed under the open source Creative Commons license.