Skip to main content
Help
Editing Step 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 10 guides that include this step.

Step Type:

Drag to rearrange

Insert the flat end of a spudger between the front display bezel and the plastic rim attached to the rear bezel near the lower right corner of the display.

Do not try to insert the spudger between the front display bezel and its plastic surround.

While carefully prying the rear display bezel away from the display assembly, use a small flathead screwdriver to pry the small steel clip nearest the bottom right corner of the display away from the edge of the front display bezel.

Repeat the above procedure until you've released all the clips along the right side of the display.

Your contributions are licensed under the open source Creative Commons license.