Skip to main content
Editing Step 3 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Carefully de-solder the black, grey, white, and orange leads (boxed in red) from the side of the circuit board near the AF lamp.

Lightly heat the joint of each lead with a soldering iron as you apply slight tension to the wire with a pair of tweezers.

Do not excessively heat the board. Also, be sure not to accidentally melt the plastic case with the side of the soldering iron.

Repeat the process until all four leads are de-soldered.

Your contributions are licensed under the open source Creative Commons license.