Skip to main content
Help
Editing Step 6 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 7 guides that include this step.

Step Type:

Drag to rearrange

Remove the following screws from the logic board:

One 2.4 mm Phillips #000 screw

This screw also holds a small metal contact beneath the logic board. It's held in place underneath a plastic bracket, but if you see it slipping out, refer to this step to remove it.

Two 2.3 mm Phillips #000 screws

Four 2.8 mm standoff screws

Standoff screws are best removed using an iPhone Standoff Screwdriver Bit and driver handle.

In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

Your contributions are licensed under the open source Creative Commons license.