Skip to main content
Help
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 10 guides that include this step.

Step Type:

Drag to rearrange

Remove the following four screws securing the power supply to the outer case:

Two 22.2 mm fine-thread T10 Torx

One 25 mm coarse-thread T10 Torx

One 9 mm coarse-thread T10 Torx

The next few steps bring your hands close to the exposed face of the power supply. To avoid a high voltage shock from the many large capacitors attached to the board, do not touch the face of the power supply.

Your contributions are licensed under the open source Creative Commons license.