Get quick access to guides, parts, and answers for your devices
Looks like your cart is empty
Remove the two 3.4mm screws that hold down the right edge of the card with a Phillips PH0 screwdriver.
The card is spring loaded at the receptacle. Unless you hold it down, the card will spring up once both screws are removed.
Allow the card to lift up, and then slide it out of the black receptacle.
When putting the card back in, make sure it is fully seated in the receptacle before pushing it down to re-insert the screws.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.