Fix Your Stuff Community Store
Help

How to Troubleshoot a GE Front Load Washer Stopping Mid Cycle and Not Spinning

Editing Step 4 —
Remove the dispenser and console screws
Start Timestamp
End Timestamp

Pull out the dispenser drawer fully and press the tab on its left side to remove it.

Locate five screws in the dispenser housing three on the left and two on the right, and remove them with a Phillips driver.

Lift the console interface up about 15 degrees and pull it forward to unlatch from the bulkhead.

Remove three screws behind the interface along the top edge of the washer lid.

Your contributions are licensed under the open source Creative Commons license.