Skip to main content
Help
Editing Step 5 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

The 3.5 mm Phillips screw indicated below with a red circle may be absent in some models.

Remove the following 5 screws and 3 nuts from the heat sink:

One 3.5 mm Phillips from the lower left corner of the heat sink.

Three 6 mm Phillips from around the fan.

One 7.5 mm Phillips at the top right corner of the heat sink.

One 4 mm nut from the side of the heat sink.

Two 4 mm screw nuts with attached springs from either side of the heat sink.

Your contributions are licensed under the open source Creative Commons license.