Skip to main content
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Use the flat end of a spudger to gently pry between the flash assembly and back cover to separate the adhesive.

Remove the flash assembly from the back cover.

You may also need to transfer the camera lens and the silicon pad from the rear case. These can be removed by prying carefully with a plastic opening tool.

Depending on the adhesive on the rear case, you may need to tape the flash assembly down to secure it.

Your contributions are licensed under the open source Creative Commons license.