The logic board is delicate. Be careful not to bend it as you free the lower edge from the frame.

Lift the top edge of the logic board from the frame.

Pull the top edge of the logic board to the right of the frame so the cutouts of the board lift over the vibration motor and protrusions in the frame.

As you pull, guide the charging port out of its recess in the frame.

Don't fully remove the logic board yet, as it's still connected to the frame by the screen cable.

During reassembly, push the logic board toward the bottom of the frame and press the charging port down until the bottom edge sits flush with its protrusion in the frame.

Make sure the flash, front-facing camera, and press connector don't become trapped under the frame.