Skip to main content
Help

Logitech MX Master 3 for Mac Mouse Feet (That Cover Screws) Removal

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 9 guides that include this step.

Step Type:

Drag to rearrange

Flip the mouse's power switch into the OFF position, unplug any cables, and flip it over so the feet are facing up.

The unique shape of some mice can prevent them from laying flat. If you need to, lay your mouse on a soft towel to prevent wobble.

If you're planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated for them to be cleanly removed.

Heat an iOpener and apply it to each of the mouse feet for about one minute each.

Alternatively, you can use a hair dryer to soften the mouse feet adhesive.

When using a hair dryer, don't heat the feet for more than a couple seconds at a time—anything hotter than just warm to the touch risks melting or warping the plastic lower case.

The information sticker adhesive may soften during this step, but you don't need to remove it.

Your contributions are licensed under the open source Creative Commons license.