Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Help
Editing Step 5 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

When reassembling your device, attach the gasket to the heat sink as shown.

The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board.

Be sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.

Your contributions are licensed under the open source Creative Commons license.