Skip to main content
Editing Step 6 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Use a flathead screwdriver to release the two clips located on the back half of the drive assembly.

The final clip doesn't need to be released; the top half of the drive assembly will slide away from the lower half.

Finish removing the top half of the drive assembly from the base.

Be careful not to detach the red wire or the white ribbon cable still attached.

Your contributions are licensed under the open source Creative Commons license.