Skip to main content
Help

Notice: You are editing a prerequisite guide. Any changes you make will affect all 12 guides that include this step.

Step Type:

Drag to rearrange

Repeat the process of heating and cutting the adhesive along the three remaining sides of the rear cover.

You can insert each new opening pick in the gaps created by the opening picks left in each corner.

As you proceed, leave an opening pick in each corner to prevent the adhesive from re-sealing.

If the rear cover is still attached to the frame after cutting through all four sides, try slicing through the adhesive again with an opening pick.

Your contributions are licensed under the open source Creative Commons license.