Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 6 guides that include this step.

Step Type:

Drag to rearrange

The center chassis is aligned to the shell with guide pegs. These pegs will need to slide out of their slots to allow the chassis to be lifted out.

Grip the center chassis and pull it towards the top of the shell, uncoupling the guide pegs from the shell.

Lift up the center chassis assembly to remove it from the shell.

During reassembly, make sure neither of the ribbon cables get pinched as you lower the center chassis into the shell.

Your contributions are licensed under the open source Creative Commons license.