Apply a suction cup to the back of the battery.
Pull up on the suction cup with strong, steady force to begin to separate the battery from the frame.
If this is difficult, apply a few more drops of isopropyl alcohol underneath the battery, let it sit for two minutes, and try again.
Insert the point of an opening pick into the gap created between the battery and frame.
Don't insert the opening pick more than halfway or you risk damaging the fingerprint sensor underneath.
Pull up on the suction cup to remove the battery.
The battery will come out without much force once the isopropyl alcohol has adequately penetrated the battery adhesive.
When you're reassembling your phone, apply stretch release adhesive strips, double sided adhesive tape, or pre-cut adhesive to secure the new battery.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.