Skip to main content
Editing Step 20 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 153 guides that include this step.

Step Type:

Drag to rearrange

Slide the opening pick along the left edge of the iPad, releasing the adhesive as you go. The adhesive is thin here due to the digitizer along the whole left side. Make sure the pick is not too deep (max 1/2 inch) 10 mm to prevent damaging the digitizer.

The digitizer cable is located approximately 2" (50 mm) from the bottom of the iPad. Stop sliding the pick when you get ~2.25" (60 mm) from the bottom of the iPad.

Your contributions are licensed under the open source Creative Commons license.