Skip to main content
Help
Editing Step 4 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 7 guides that include this step.

Step Type:

Drag to rearrange

The screen is now connected only by a small cable that runs to the rear board of the camera. Using tweezers, slowly pull the cable out of the connector.

For best results, grip the cable as close to the connector as possible.

The screen should now be separate from the camera body. Be careful not to harm the connectors on the lens so it will reconnect successfully.

Your contributions are licensed under the open source Creative Commons license.