Skip to main content
Editing Step 8 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 12 guides that include this step.

Step Type:

Drag to rearrange

Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges.

Do not let any of the exposed solder joints come in contact with a metal surface, as that can cause a short.

Flip the power supply over to access the DC power cable connection behind the logic board.

To disconnect the cable, squeeze the release clip on the back side of the connector, behind the logic board, and pull the connector straight out.

Your contributions are licensed under the open source Creative Commons license.