Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Remove all eleven screws securing the logic board assembly:

Three 3.3 mm T3 Torx screws

Two 3.6 mm T5 Torx screws

Four 2.9 mm T5 Torx screws

One 4.0 mm T8 Torx screw

One 4.0 mm T8 Torx screw (large head)

During reassembly, install these screws only loosely. Adjust the board position if necessary until all the connectors line up, and then tighten the screws.

Your contributions are licensed under the open source Creative Commons license.