Skip to main content
Help
Editing Step 2 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 12 guides that include this step.

Step Type:

Drag to rearrange

Disconnect the camera cable by pulling the male end straight away from its socket.

There is a small piece of hard plastic stuck to the logic board that stops the camera cable from falling out of its socket. Be sure to peel this off first or you could damage the connectors.

Make sure to pull the connector parallel to the face of the logic board and toward the optical drive, not straight up from its socket.

Your contributions are licensed under the open source Creative Commons license.