Skip to main content
Help
Editing Step 8 —

Step Type:

Drag to rearrange

Tape the end of the thermistor wires to the orange sleeve. This will make install easier later

Pull the old chain off the machine.

Hold the wires on the bed side.

Start pulling the cable chain away from the bed.

With the old chain fully removed, notice the taped end. This will make installing into the new chain much easier.

Be gentle! If the cables get stuck, pull the wire back through and inspect your taped areas. They must be smooth and small to fit through the old chain then retry

Your contributions are licensed under the open source Creative Commons license.