Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 9 guides that include this step.

Step Type:

Drag to rearrange

Remove the five screws securing the logic board connector bracket to the rear case:

One 1.3 mm Phillips #000 screw

One 1.5 mm Phillips #000 screw

Three 1.2 mm Y000 screws

Remove the bracket.

Be careful not to lose the smaller bracket clipped onto the edge. It's secured with a small clip and is easy to accidentally knock off of the larger bracket.

Your contributions are licensed under the open source Creative Commons license.