Skip to main content
Help
Editing Step 5 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 4 guides that include this step.

Step Type:

Drag to rearrange

Next, remove the ten 5.92mm T5 torx screws located underneath the kickstand.

Remove the seven 5.87mm T5 torx screws located under the camera casing. There is a sticker covering the second screw from the left.

Disconnect the rear cover from the main shell of the system by loosening it with a spudger where the gaps exist.

There is an electrical ribbon connecting the rear cover to the motherboard. Do not pull apart the rear cover from the motherboard once you have loosened the rear cover from the main system.

Continue working your way around to each corner and loosen the snap-ons on each side until the rear cover comes off.

Your contributions are licensed under the open source Creative Commons license.