Carefully flip the board over and note the two solder joints connected to the battery cables.
De-solder the two solder joints and replace the battery. You will have to re-solder the battery to these contact points.
Alternatively, cut the wires one-by-one before you desolder them. This will help prevent unintentional short circuitry.
Be very careful not to short the battery wires. Doing so may overheat and ignite the battery.
Be sure to maintain the correct battery polarity when you re-solder the wires.
The back of the board is shown for reference.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.