Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Editing Step 25 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Remove all ten screws securing the logic board assembly:

Two 2.6 mm T3 Torx screws

Five 2.9 mm T5 Torx screws

One 3.7 mm T5 Torx screw

One 3.9 mm T8 Torx screw (large head)

One 4.0 mm T8 Torx screw

During reassembly, install these screws only loosely. Adjust the board position if necessary until all the connectors line up, and then tighten the screws.

Your contributions are licensed under the open source Creative Commons license.