Skip to main content
Help
Editing Step 10 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 5 guides that include this step.

Step Type:

Drag to rearrange

During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket.

Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.

If you have slender hands, you may be able to press the connector into place with your finger. Just be careful not to strain the cable.

This takes patience and a bit of practice. Don't rush it or attempt to force the connector into place.

Your contributions are licensed under the open source Creative Commons license.