Skip to main content
Editing Step 25 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Remove the ten screws securing the logic board assembly:

Two 2.8 mm T3 Torx screws

Five 2.9 mm T5 Torx screws

One 3.7 mm T5 Torx screw

One 3.9 mm T8 Torx screw

One 3.8 mm T8 Torx screw

During reassembly, install these screws only loosely. Adjust the board position if necessary until all the connectors line up, and then tighten the screws.

Your contributions are licensed under the open source Creative Commons license.