Skip to main content
Help
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 35 guides that include this step.

Step Type:

Drag to rearrange

Be very careful to pry evenly on the digitizer connector, and not on the socket at all. The socket and connector are very delicate and if you damage either, your digitizer won't work.

To minimize stress on the socket, try prying under the short edge of the connector, rather than the long edge which is shown in these images.

Gently pry the digitizer connector up from its socket on the logic board.

Your contributions are licensed under the open source Creative Commons license.