Skip to main content
Help
Editing Step 4 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 22 guides that include this step.

Step Type:

Drag to rearrange

Insert the flat end of a spudger between the front bezel and the plastic strip attached to the rear bezel near the screw holes at the bottom corners of the display.

Rotate your spudger toward the rear bezel to separate it from the front bezel.

If necessary, enlarge the gap between the lower edge of the rear bezel and the clutch cover until the two components are completely separated.

Your contributions are licensed under the open source Creative Commons license.