Skip to main content
Editing Step 2 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Disconnect the inverter cable by pulling its connector away from the socket on the inverter board.

The inverter board is a very thin and delicate circuit board that is easily broken. Use caution.

This connector tends to stick in its socket. It is helpful to push the connector with the tip of a spudger through the two small holes in the top of the socket while pulling the connector away from the socket.

Make sure to grasp the inverter cabling by the black tape and not the individual wires. Pulling the wires themselves will surely damage the inverter cable.

Your contributions are licensed under the open source Creative Commons license.