Skip to main content
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Begin by removing the two black 16 mm Phillips #0 screws. The screws can be identified by the two notches next to each screw. One (marked in red) is near the battery lock and the other (not pictured) is next to the Wi-Fi cover.

Push up the bottom of the keyboard by poking your finger through the hole to the right of the yellow bios battery. You will feel slight resistance.

Be sure to not lift the keyboard too far. It is still attached to the computer with a ribbon connector.

Your contributions are licensed under the open source Creative Commons license.