Skip to main content
Editing Step 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Use the 10 mm socket wrench to unscrew the first of three 12 mm long 10 mm hex-head screws holding in the headlight assembly. The screw is located just to the left of the headlight assembly.

Unscrew the second screw located approximately 6 inches below the first.

Locate the third screw at the bottom left corner of the headlight assembly just behind the bumper and remove.

When re-installing the screws do not over tighten. Over tightening the screws will result in stripped threads.

Your contributions are licensed under the open source Creative Commons license.