Skip to main content

Fix Your Stuff

Right to Repair


Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Use a thin pry tool or tweezers to carefully pry up and disconnect the upper coaxial cable connector from the logic board.

There are two coaxial connectors in close proximity. Disconnect the one nearest the battery connector.

During reassembly, this can be tricky to reconnect. Hold the connector in place over its socket and press down with the flat of your spudger. The connector should snap into place.

Your contributions are licensed under the open source Creative Commons license.