Skip to main content

Fix Your Stuff

Right to Repair


Editing Step 28 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

When reinstalling the logic board assembly:

Check the alignment of the rubber vibration dampers, and adjust them as needed.

Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

Your contributions are licensed under the open source Creative Commons license.