Skip to main content
Help
Editing Step 14 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 6 guides that include this step.

Step Type:

Drag to rearrange

Remove the display.

During reassembly, if you wish to replace the display adhesive strips, first use a spudger to scrape away all the old adhesive, and clean the adhesion area with some high-concentration (at least 90%) isopropyl alcohol on a lint-free cloth.

Apply a thin, high-bond tape, like 1 mm Tesa 61395, or a strip from a precut adhesive card, where the old adhesive was.

If you're installing a new display assembly, note where the adhesive is on the original assembly and apply adhesive in the same places on the new assembly.

Your contributions are licensed under the open source Creative Commons license.