Help
Editing Step 11 —

Step Type:

Drag to rearrange

ABS plastic was chosen for the prints because of its durability and ease of availability. For these parts, I am using an orange pigment ABS plastic. UV stabilized ABS filament would be a great candidate for this print but it was not available at the time of print.

An SLA (Stereolithography) 3D printer is not ideal in this case because this is a thin walled part (<1mm wall thickness) that may be exposed to extended outdoor use. UV curable resin is not very tolerant of excess external UV radiation and the material properties of the resin can change over time with additional UV light.

UV curable resin is also susceptible to creep and can discolor, which is not desirable for a replacement camera part.

Your contributions are licensed under the open source Creative Commons license.