Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Editing Step 16 —

Step Type:

Drag to rearrange

Six parts were printed to serve as examples of minor part design iterations. This was intentional in case I made an error in measurement. Four additional prints were made as extras in case the parts were damaged during cleanup.

A good way to keep track of different part iterations is to engrave revision letters or numbers into the part printed. In this case, I embedded the label into the bottom of the cap where it would not be seen.

S = stepped geometry on cut 16

W = Wider semicircle on cut 17

N = Notched length on cut 11

Your contributions are licensed under the open source Creative Commons license.