Skip to main content
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 7 guides that include this step.

Step Type:

Drag to rearrange

Remove the grey scuff guard at the bottom of the PC by pressing down on it, and pulling it away.

Lift the hinge and remove the grey rubber tabs on either side of the PC’s model information.

Remove the two 7.62mm Phillips #1 screws beneath the rubber tabs under the hinge and the four 7.62mm Phillips #1 screws where the scuff guard was removed.

Remove the two 4.74mm Phillips #1 screws under the hinge (near the hinge joints) and a 4.74mm Phillips #1 screw under the handle.

Your contributions are licensed under the open source Creative Commons license.