Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Editing Step 5 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

In the following steps, you will use a heat gun to soften the adhesive securing the outer silver border around the underside of the front panel to the display.

With the heat gun set to low, start by heating the metal bezel surrounding the LCD.

When using the heat gun, the goal is to soften a layer of adhesive holding the bezel to the display assembly. Be very careful not to overheat the LCD, as it could cause permanent damage.

Your contributions are licensed under the open source Creative Commons license.