Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Help
Editing Step 2 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Locate and remove the 8mm screw with a screwdriver and the T10 torx bit, then remove the paper control sensor board.

In this picture, the main circuit board is removed. It is not necessary to remove the main circuit board unless the paper control sensor is not the only part being replaced.

Your contributions are licensed under the open source Creative Commons license.