Using a block of scrap wood between a hydraulic jack and the oil pan, use the jack to support the engine
Do not lift the engine! Merely allow it to rest on the jack.
Mark the position of the motor mount relative to the car frame with a sharpie
There are three 15mm bolts holding the motor mount to the car frame.
During reassembly these bolts must be torqued to 48 Nm
There are two 18mm nuts holding the motor mount to the engine
It is normal for the stud to come out with these nuts
During reassembly these bolts must be torqued to 80 Nm
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.